Product Overview
Galvanised steel light-duty restraint strap with a 1000mm length and bend positioned at 100mm.
Manufactured from pre-galvanised mild steel, this restraint strap provides reliable structural anchorage for lightweight timber and masonry connections. It is ideal for vertical or horizontal restraint applications where moderate holding strength is required.
Factory-formed 90° bend positioned 100mm from the end allows direct fixing to perpendicular structural surfaces for secure wall plate or joist restraint, while precision-punched holes ensure secure fixing to timber, blockwork, or concrete.
With its corrosion-resistant galvanised finish, the strap offers lasting durability in internal and sheltered environments.
1000mm strap designed for long-span or deep-section restraint in roof and floor systems.
Features & Benefits
- Galvanised steel: Formed from pre-galvanised mild steel for balanced strength and corrosion resistance.
- Bend configuration: Allows installation around joists, beams, or masonry with correct alignment.
- Fixing holes: Pre-punched at regular intervals for uniform load transfer and secure connection.
- Corrosion protection: Zinc coating prevents rust and degradation in service.
- Structural reliability: Suitable for restraint of light roof members, wall plates, and joists.
- Length: 1000mm suitable for extended restraint between structural members.
Applications
- Roof restraint: For securing wall plates or light truss bearings.
- Joist connection: Provides restraint between timber joists and supporting masonry.
- Internal wall restraint: Used to tie internal walls or partitions to main structural members.
- General light-duty fixing: Appropriate where moderate restraint and corrosion protection are required.
Installation Guidance
- Fixing method: Secure with appropriate nails, screws, or bolts through pre-punched holes.
- Orientation: Install flat against the substrate for optimal bearing and strength.
- Support alignment: Ensure direct alignment between strap and fixing surface for load efficiency.
- Fastener selection: Use corrosion-resistant fixings to maintain system durability.
- Cutting or modification: Avoid field cutting to preserve galvanised coating and corrosion protection.
Compliance & Performance
- Material standard: Manufactured from galvanised steel to BS EN 10346 DX51D + Z275.
- Load suitability: Designed for light-duty restraint applications in accordance with BS 5268-3.
- Corrosion resistance: Zinc coating equivalent to 275 g/m² for long-term protection.
- Manufacturing quality: Produced under controlled conditions for dimensional accuracy and hole spacing.
- Important note: Always verify suitability of restraint strap type and length before installation in structural applications.